![]() ![]() Because of this and its low thermal conductivity, it is also used in fused filament fabrication (FFF) printing to thermally separate the hot end from the cold end. PEEK also performs well in high temperature applications (up to 500 ☏/260 ☌). PEEK seals and manifolds are commonly used in fluid applications. It is radiolucent, but it is hydrophobic causing it to not fully fuse with bone. PEEK is used in spinal fusion devices and reinforcing rods. PEEK is used in medical implants, for example in creating a partial replacement skull in neurosurgical applications. It is one of the few plastics compatible with ultra-high vacuum applications, which makes it suitable for aerospace, automotive, and chemical industries. PEEK is used to fabricate items for demanding applications, including bearings, piston parts, pumps, high-performance liquid chromatography columns, compressor plate valves, and electrical cable insulation. It has high resistance to biodegradation. It is soluble in concentrated sulfuric acid at room temperature, although dissolution can take a very long time unless the polymer is in a form with a high surface-area-to-volume ratio, such as a fine powder or thin film. ![]() It is attacked by halogens and strong Brønsted and Lewis acids, as well as some halogenated compounds and aliphatic hydrocarbons at high temperatures. It is highly resistant to thermal degradation, as well as to attack by both organic and aqueous environments. ![]() The thermal conductivity increases nearly linearly with temperature between room temperature and solidus temperature. Some grades have a useful operating temperature of up to 250 ☌ (482 ☏). PEEK has a glass transition temperature of around 143 ☌ (289 ☏) and melts around 343 ☌ (662 ☏). Its Young's modulus is 3.6 GPa and its tensile strength is 90 to 100 MPa. The processing conditions used to mould PEEK can influence the crystallinity and hence the mechanical properties. PEEK is a semicrystalline thermoplastic with excellent mechanical and chemical resistance properties that are retained to high temperatures. The reaction is conducted around 300 ☌ in polar aprotic solvents - such as diphenyl sulfone. Typical is the reaction of 4,4'-difluorobenzophenone with the disodium salt of hydroquinone, which is generated in situ by deprotonation with sodium carbonate. PEEK polymers are obtained by step-growth polymerization by the di alkylation of bis phenolate salts. The polymer was first developed in November 1978, later being introduced to the market by Victrex PLC, then Imperial Chemical Industries (ICI) in the early 1980s. The speed control board includes an automatic, variable voltage control module that is engineered to regulate the precise RPM of the screw.Polyether ether ketone ( PEEK) is a colourless organic thermoplastic polymer in the polyaryletherketone (PAEK) family, used in engineering applications. The EX6 features extrusion speed control and a 4 zone temperature control system. All screws have a 24:1 L/D ratio giving greater versatility and control compared to other extruders.Ĭlick here to learn about the other available screws. With this new system, screws with different characteristics can be used as needed for each specific polymer, allowing screw designs to be tested and polymer output and consistency optimized. The screw can be easily removed for cleaning and can be swapped out with the various other screw profiles to match the processing requirements of the polymer. The EX6 features a three-stage extrusion screw made from hardened and polished high-carbon stainless steel. ![]() The Filabot EX6 extruder is our professional-level system, designed to be the best system for developing new polymers and for production of filament. South Georgia & South Sandwich Islands (GBP £) ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |